Autel Autolink AL619 Bedienungsanleitung PDF herunterladen (Seite 39)

5.6 O2 Monitor Test

OBD2 regulations set by SAE require that relevant vehicles

monitor and tests on the oxygen (O2) sensors to identify problems

related to fuel efficiency and vehicle emissions. These tests are not

on-demand tests and they are done automatically when engine

operating conditions are within specified limits. These test results

are saved in the on-board computer's memory.

The O2 Monitor Test function allows retrieval and viewing of O2

sensor monitor test results for the most recently performed tests

from the vehicle's on-board computer.

The O2 Monitor Test function is not supported by vehicles which

communicate using a controller area network (CAN). For O2

Monitor Test results of CAN-equipped vehicles, see chapter

“On-Board Mon. Test”.

1) Use the UP/DOWN scroll button to select O2 Monitor Test

from Diagnostic Menu and press OK button. (Figure 5.3)

2) Wait a few seconds while the scan tool validates the PID MAP.

3) Use the UP/DOWN scroll button to select O2 sensor from O2

Monitor Test menu and press OK button. (Figure 5.24)

Figure 5.24

 If the vehicle does not support the mode, an advisory message

will be displayed on the screen. (Figure 5.25)

.......... ..O2 Monitor Test …

1.O2 Bank1 Sensor1

2.O2 Bank1 Sensor2

3.O2 Bank2 Sensor1

4.O2 Bank2 Sensor2

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 65 66

Keine Kommentare

Autel Autolink AL619 Bedienungsanleitung Seite 39